Please read this instruction carefully before installation!

	Required tools: 96% ethyl alcohol (spirit) cotton cloth hair-drier
	1. Cleaning the surfaces Remove all grease from the surfaces on which the dash trim is to be stuck with a 96% ethyl alcohol (spirit). Repeat the cleaning if necessary.
2. Warning! Do not stick the parts if the temperature inside the car is below 18 °C. When sticking, do not touch the surfaces which are covered with glue. Use only a clean cotton cloth that does not shed snippets for removing grease. Before the installation check that the upholstery has not faded or been damaged under the influence of the cleaning agent (alcohol) and the carrier glue (it applies especially to leather car upholstery). The parts may not be stuck onto the airbags under any circumstances!
	3. Heating Heat the surfaces of the parts slightly to a temperature of about 35-50 °C with the use of a hair-drier (do not remove the transport paper). 4. Removing the paper Remove the transport paper from the part which is to be stuck, then fit it to an appropriate place.
	5. Fiting the dash trim-kit When the part fits its place, press it against the surface and hold pressed for a moment. Warning: On bigger surfaces, the parts are to be stuck like wallpaper, so make sure that no air gets under the dash trim. When stuck, the glued parts should be heated once again (temperature 35-40 °C) being pressed at the same time.

models
colours
prices
Assembly
gallery